250 Mag Mikuni Conversion Kit
Made to Replace Bing carb on 74 250 Mag
Complete kit consists of everything you need to replace the bing carb on your 1974 250 mag husky. This is a bolt on set up and does not require any cutting, welding, fabricating or rigging. After many requests for an easy to install Mikuni conversion, this kit is now available. The Mikuni carb is known for its precise fuel metering capabilities and leak proof design. The choke system is also more advanced with the lever rather than the tickler that dumps fuel on the engine. There are many reasons why Husqvarna switched to the Mikuni as original equipment on its later model bikes in 1978. Your bike will start easier and run cleaner with better throttle response, less fouled plugs and fewer load ups. This conversion will take about 30 minutes to install. It comes with the following new parts. (1) intake gasket, (1) billet Mikuni intake plate, (1) rubber Mikuni adapter with (2) 8mm stainless socket head bolts, (1) 36mm Mikuni carb, (1) billet mag airbell including rubber sealing ring installed and (3) aluminum mounting straps with alloy spacer. The carb is pre jetted for 1050 feet (320 m) above sea level and should be spot on in the southern USA. This jetting works great here in Atlanta, Georgia. You may need to dial in your own jetting depending on your location and should always test any new set up with a plug reading prior to any long ride or competition. Riding your bike with incorrect jetting can cause engine damage or failure.